Inserting The Tool - BDS Maschinen MAB 100 Instrucciones De Manejo

Preparations
Steel of low thickness
NF metals or workpieces with an uneven surface

Inserting the tool

40
When drilling in steel of low thickness, an additional steel plate
(minimum dimensions 100 x 200 x 20 mm) must be placed under
the workpiece. Secure the steel plate to prevent it from falling.
A special holding device must be used when drilling in NF metals
or in workpieces with an uneven surface.
NOTE
► BDS offers special clamping devices for tubes and non-
magnetic materials in its range of accessories.
The machine is equipped with a 19 mm Weldon tool mount, and
can provide drilling up to 30 mm of length.
WARNING
Risk of injury!
► Do not use damaged, soiled or worn tools.
► Carry out tool changes only when the machine is switched
off and at a standstill. Remove plug from the mains socket.
► After inserting, check that the tool is engaged securely.
► Only use tools, adapter and accessories that match the
machine.
MAB 100