Inserting The Tool - BDS Maschinen MAB 1300 Instrucciones De Manejo

P r e p a r a t i o n
In s e r t i n g t h e t o o l
Sa f e t y p r e c a u t i o n s
1 8
The machine is equipped with an MK tool holder . Depending
on the type of tool to be used, corresponding tool holders, drill
chucks or adapters must be employed .
T o o l
Tools with
1 1 / " (32mm)
4
Weldon shank
Tools with
3 / " (19mm) Weldon
4
shank
Tool with
MK4 taper
Tool with
MK3 taper
Tools with
straight shank
drill taps
W A R NING
R i s k o f i n j u r y !
► Do not use damaged, soiled or worn tools .
► Carry out tool changes only when the machine is switched
off and at a standstill . Remove plug from the mains socket .
► After inserting, check that the tool is engaged securely .
► Only use tools, adapter and accessories that match the
machine .
t o o l h o l d e r t o b e u s e d
Use MT4 (MK4) / Weldon 1
tool holder with retainer (delivery
condition) .
Use ZAP 200 reducing ring .
Insert the tool directly into the morse taper
(5) . Dismantle the tool holder with the
retainer .
Use adapter sleeve (available as an
accessory) . Dismantle the tool holder with
the retainer .
Use drill chuck with tapered mandrel
(available as an accessory) . If necessary,
use an adapter sleeve .
Use industrial tool holder with Weldon
Shank and matching ZGA adapter for drill
taps (available as an accessory) .
1 / " (32mm)
4
M A B 1 3 0 0