Button Sewing - Brother XL5010 Manual De Instrucciones

Button Sewing

XL5030 XL5020 XL5010 Pattern
4, 5, 6 4, 5, 6 2, 3, 4 Zigzag Stitch
1. Measure the distance between the holes and select the appropriate
pattern with the pattern selection dial.
Distance between holes
1.7 mm (1/16")
3.5 mm (9/64")
5 mm (13/64")
2. Attach the button sewing foot.
3. Place the darning plate on the needle plate.
(When the machine is equipped with a drop feed lever, lower the
feed dogs by setting the drop feed lever to the up position.)
4. Place a button between the foot and the fabric and make sure that
the needle enters the holes without hitting the button. If it hits, see
step 1.
5. At a slow speed, sew approximately 10 stitches.
6. Remove the material from the machine. Cut the upper and lower
threads and tie the two threads at the back of the fabric.
Stitch Length Foot
Button
Any
Sewing Foot
Pattern
4 4 2
5 5 3
6 6 4
XL5030 XL5020 XL5010
54