Fitting the loop handle
•
Position the loophandle on the shaft. Note that the
handle must be mounted between the arrows on the
shaft.
•
Fit the screw, securing plate and wing nut as shown in
the diagram.
•
Tighten the wing nut.
Fitting the trimmer head
WARNING! When fitting the cutting
!
attachment it is extremely important that
the raised section on the drive disc/
support flange engages correctly in the
centre hole of the cutting attachment. If
the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
1141338-49 Rev. 1 2019-04-19
ASSEMBLY
Fitting the trimmer guard and
trimmer head
•
Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
•
Fit the drive disc (B) on the output shaft.
•
Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
•
To dismantle, follow the instructions in the reverse
order.
H
H
–
English
11