Drinkwell AVALON-AU-17 Manual De Funcionamiento página 13

3. Remove the extra slack from the electrical
power cord and insert the Rubber Cap into
the raised post. Make sure the cord channel
on the Rubber Cap is aligned with the
electrical power cord, then insert your finger
into the Rubber Cap and push all the
way down (Fig. 19).
4. Fold the top of the Rubber Cap over the raised
post to seal off the Bowl.
5. Rinse a new Charcoal Filter thoroughly in cold
water to help remove any excess and loose
charcoal dust.
6. Once the Charcoal Filter is rinsed off, place
inside the Base of the Filter Housing with the
larger side facing down. The Charcoal Filter will
only fit inside the Base one way, if it does not fit,
flip it over. Attach the Lid to the Filter Housing,
press down until you hear it snap in place.
7. Attach the Filter Housing to the Pump by
inserting the raised round notch inside the
circular opening on top of the Pump. The
opening on top of the Filter Housing should be
right next to the raised post (Fig. 20).
8. Reinsert the Rubber Grommet into the circular
opening at the top of the Tower. Place the
Rubber Grommet inside the hole and then
gently work the piece into the hole so that
the top edge rests flat inside the dish. This will
create a seal between the Filter Housing and
the Tower (Fig. 21).
9. Align the Tower with the circular indentation
inside the Bowl and carefully lower it until it rests flat (Fig. 22).
10. Fill the Pet Fountain by pouring water directly into the Bowl. Leave at least a 1.27 cm of
space between the water level and the rim of the Bowl to help control spills and splashing.
1 1. Place the Pet Fountain in desired location. Do not pick up a full Pet Fountain by the
Tower piece. To properly pick up the Pet Fountain, use both hands and grip the
sidewalls of the Bowl and lift. Important: To protect your floor always use a
protective mat, such as a towel or water-resistant placemat. This will help protect your
floor from splashing or spills caused by your pet.
12. Make sure the electrical power cord, the adaptor and your hands are completely dry
before you plug the Pet Fountain into an electrical outlet. Connect the Inline Plug and
make sure no silver is showing, then plug the adaptor into an electrical outlet.
Fig. 20
Fig. 22
www.petsafe.net
Fig. 19
Cord
channel
Fig. 21
13