Chain Saw Safety Warnings - Ryobi RY40507 Manual Del Operador

GENERAL POWER TOOL SAFETY RULES
SERVICE
 Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
 Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
 Keep all parts of the body away from the
saw chain when the chain saw is operating.
Before you start the chain saw, make sure
the saw chain is not contacting anything. A
moment of inattention while operating chain
saws may cause entanglement of your clothing
or body with the saw chain.
 Always hold the chain saw with your right
hand on the rear handle and your left hand on
the front handle. Holding the chain saw with a
reversed hand configuration increases the risk
of personal injury and should never be done.
 Hold the power tool by insulated gripping
surfaces only, because the saw chain may
contact hidden wiring. Saw chains contacting
a "live" wire may make exposed metal parts of
the power tool "live" and could give the operator
an electric shock.
 Wear eye protection. Further protective
equipment for hearing, head, hands, legs
and feet is recommended. Adequate protec-
tive equipment will reduce personal injury from
flying debris or accidental contact with the saw
chain.
 Do not operate a chain saw, on a ladder, from
a rooftop, or any unstable support. Operation
of a chain saw in this manner could result in
serious personal injury.
NOTE: The size of the work area depends on the
job being performed as well as the size tree or
work piece involved. For example, felling a tree
requires a larger work area than making bucking
cuts.

CHAIN SAW SAFETY WARNINGS

 When servicing a power tool, use only identi-
cal replacement parts. Follow instructions in
the Maintenance section of this manual. Use
of unauthorized parts or failure to follow main-
tenance instructions may create a risk of shock
or injury.
 Do not operate a chain saw in a tree unless
you have been specifically trained to do so.
Operation of a chain saw in a tree without proper
training could increase the risk of serious per-
sonal injury.
 Always keep proper footing and operate
the chain saw only when standing on fixed,
secure and level surface. Slippery or unstable
surfaces such as ladders may cause a loss of
balance or control of the chain saw.
 When cutting a limb that is under tension be
alert for spring back. When the tension in the
wood fibres is released the spring loaded limb
may strike the operator and/or throw the chain
saw out of control.
 Use extreme caution when cutting brush and
saplings. The slender material may catch the
saw chain and be whipped toward you or pull
you off balance.
 Follow all instructions when clearing jammed
material, storing or servicing the chain saw.
Make sure the switch is off and the battery
pack is removed. Unexpected actuation of the
chain saw while clearing jammed material or
servicing may result in serious personal injury.
 Carry the chain saw by the front handle with
the chain saw switched off and away from
your body. When transporting or storing the
chain saw always fit the guide bar cover.
Proper handling of the chain saw will reduce the
likelihood of accidental contact with the moving
saw chain.
4 - English