Cameo FLAT PRO Serie Manual De Usuario página 22

COLOUR BLENDING
In the colour fade mode (fading mode) different colours are blended into one another in succession. The speed of the program is adjustable
separately and a stroboscope effect can also be activated.
Press the MODE button until "FADING" appears in the upper line of the display. Now, press ENTER until the cursor appears in the lower line of
the display, and then select the rate (SPEED) using the UP and DOWN buttons, with the colours alternating from 00 to 99.
Confirm with ENTER. The indicator in the bottom line of the display changes to "FLASH:xx". The cursor will appear in the bottom line at the same
time and you can activate the stroboscope effect using the UP and DOWN buttons and adjust the flash frequency from 00 to 99 (FLASH:00 = strobe
deactivated, FLASH: 01 = approx. 1 Hz, FLASH: 99 = approx. 20 Hz). Confirm with ENTER.
COLOUR BLENDING
Rate SPEED:00 - SPEED:99
AUTO MODE
Press the MODE button repeatedly until „AUTO MODE" appears on the display. In this operating mode, the light switches automatically between
colour change and colour blending mode. The colour change and/or colour blending rate is determined by the settings of the respective mode. A
stroboscopic effect cannot be activated.
SLAVE MODE
Press the MODE button repeatedly until „SLAVE MODE" appears on the display. Connect the slave and the master unit (same series) with a DMX
cable. Now the slave unit follows the master unit.
SELECTING DMX MODE
Press the MODE button repeatedly until „DMX MODE" appears in the upper line of the display. Press ENTER, and the cursor appears in the lower line
of the display and then use the UP and DOWN buttons to select one of the five DMX modes (02CH, 03CH1, 03CH2, 05CH, 08CH). Confirm with ENTER.
You will find tables with the channels of the different DMX modes on the following pages of this manual.
DMX START ADDRESS
Press the MODE button repeatedly until „DMX ADDR" appears in the upper line of the display. Press ENTER, and the cursor appears in the lower line
of the display and then use the UP and DOWN buttons to select the desired DMX start address between 001 and 512. Confirm with ENTER.
You will find tables with the channels of the different DMX modes on the following pages of this manual.
LOCK FUNCTION
To protect the projector against accidental and unauthorised operation, there is a possibility to lock the controls. Press the UP and DOWN buttons
simultaneously for 5 seconds. The display now shows LOCKED and it is no longer possible to change the settings of the projector using the control
keys. To unlock, press the UP and DOWN buttons simultaneously for 5 seconds. Now the display will change to the previously displayed information.
AUTO LOCK
In addition to the ability to protect the projectors manually against accidental or unauthorised operation, this function can also be carried out
automatically.
Press the MODE button until „AUTOLOCK" appears in the upper line of the display. Press ENTER, and the cursor appears in the lower line of the
display and then use the UP and DOWN buttons to select the desired operating mode „ON" or „OFF". Confirm with ENTER.
Select „AUTOLOCK ON" and the controls of the projector are locked automatically after approx. 40 seconds and the lighting of the display goes out.
To unlock, press the UP and DOWN buttons simultaneously for 5 seconds. Now the display will change to the previously displayed information.
22
STROBOSCOPE
Flash frequency FLASH:00 - FLASH:99