Technical Parameters; Static Electricity; Before First Use - UFESA AS3100 Manual De Instrucciones

●
Vacuum cleaner is a universal device with
a switchable sucking brush nozzle, which is used
for vacuuming hard floors and carpets.

Technical parameters

The type of the vacuum cleaner and the technical
parameters are indicated on the rating label. Mains
protection 16 A.
Does not cause interferences with audio/video devices.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing
the Directive of the European Parliament and of the
Council 2009/125/EC with regard to eco-design
requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament
and of the Council 2010/30/EU with regard to energy
labelling of vacuum cleaners.
Noise level: 84 dB(A).

Static electricity

In the process of vacuuming of some surfaces in areas
of low air humidity the device may become electrically
charged. It is a natural phenomenon – it does not
damage the device, and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend
you to:
● discharge the device by touching metal items in the
room with the pipe,
● increase air humidity in the room,
● use widely available antistatic agents.
Appliance elements
1 Outlet filter cover
2
Fastening for the nozzle brush
3
Plug with the power cord
4
Locker for the crevice nozzle
5
Fastening of the upper cover
6
ON/OFF button
7 Suction power regulation dial
8
Cord winder button
9
Handle
10
Bolt – a mechanic controller of suction power
11 Suction hose
12
Telescopic suction pipe
13
Outlet microfilter (installed in the vacuum cleaner)
14
EPA E12 basic filter (installed in the "CYKLON" dust
container)
15
EPA E12 basic filter protective casing (installed in
the "CYKLON" dust container)
16
"CYKLON" dust container (a removable part of the
vacuum cleaner)
17
"CYKLON" dust container cover
18 Switchable combination brush
19
Crevice nozzle
20
Small nozzle
21
BNB (Brush Natural Bristle) floor brush

Before first use

1
Put the end of the suction hose to the inlet of the
vacuum cleaner. Pay attention to insert the protrusions
situated on the end of the hose into the special
incisions in the inlet of the vacuum cleaner.
2
With a clockwise movement turn the end of the
suction hose tight.
3
Attach the other end of the hose (the handle)
to the suction tube. In order to do this, press the lock A
in the telescopic suction tube and put the tube in the
handle, so the lock A is fastened in hole B.
4
Select the needed length of the telescopic suction
pipe by sliding the slider according to the arrow, and
pulling the pipe out/in.
5
Install a nozzle or a brush on the other end of the
suction pipe.
6
Use combination carpet & floor brush for vacuuming
both hard surfaces and carpets. To clean hard surfaces
A
– wooden floors, plastic floors, ceramic tiles etc. pull out
the brush by pressing the switch on the combination
brush according to the figure
when vacuuming carpets (set the switch in "
7
Grab the plug of the cord (3), and pull it out of the
vacuum cleaner.
When pulling out the cord pay attention
to the yellow band which marks the end
of the cord. Any attempts to unwind the
cord further (especially forcefully pulling on it)
may lead to damaging it.
8
Put the plug of the cord in an electric socket.
B
. Retract the brush
").