Publicidad
© MOSA
1.0-06/99
It is strictly forbidden to connect the group
ÿ
to the public mains a/o to another source of
electric power.
!
WARNING
Sockets are not self-locked: tension is avaible
immediately after starting also with no plug.
!
WARNING
The areas, access of which is forbidden to
unqualified personel, are:
- the control switchboard (front), the exhaust of
the endothermic engine.
At the beginning of every work, check the
electric parameters and/or the controls placed
on the front.
Make sure the unit is properly grounded (12) (where
it is assembled).
- See page M20, 21, 22, 25, 26, 27 -.
Move the accelerator lever (16) and reach the engine
maximum speed, except for the engines with
constant rpm; the voltmeter (N) (where it is
assembled) shows the single-phase voltage whether
three or single-phase current has to be drawn.
Nominal
Indicative no-load voltage
voltage
asynchronous
110V
10%
±
230V
10%
±
230V
10%
±
400V
10%
±
with electronic tens. regul. RVT ±1%
*N.B.:
Connect up the machine, using proper plugs and
cables in good condition to the AC socket (15) to
draw single or three-phase power, or, by cables
with adeguate section, to the terminal board, placed
inside the derivation box (Q3).
The warning light (L), located near the current
socket, lights up when the unit can supply alternated
current, on condition that the engine is at the
maximum rpm.
USE AS A GENERATOR
synchronous (*)
5%
±
5%
±
5%
±
5%
±
GE_, MS_, TS_
N.B.: if the warning light does not flash, check
the accelerator which must bebat its
maximum, or the fuse of the relevant
socket.
thermoprotection.
Using several sockets at tha same time, the
maximum power possible is that indicated on the
data plate.
To draw power simultaneously in the TS welder
version see page M52.
!
CAUTION
The replacement of the fuse must absolutely be
done with the engine off (remove the mechanical
protection, then shift down the small lever of the
fuse holder placed on the front panel).
The max. continuous power of the generating set or
theload current must not be exceeded.
MACHINE WITH THERMOPROTECTION
If you overload the genset the thermoprotection will
automatically switch off.
lf the thermoprotection is released, disconnect all
the connected loads.
CLOSED
Reset the thermoprotection pressing the central
pole.
When reset, connect the loads again.
In case the protection should act furtherly, check:
the connections, the wires or others, and if
necessary call the Assistance Service.
PRESS TO
RESET
Otherwise, in case of trouble, it will not click,
damaging the generating set.
(single-phase)
or
OPEN
AvoId to hold the central
pole
of
t h e r m o p r o t e c t i o n
pressed for a long time.
M
37
the
the
Publicidad
