Publicidad
PARAMETER SETTING BY REMOTE CONTROL IN MANUAL OF RC-100 Wiring Diagrams.
BRl823-B-D wiring with dimming ballast or LED driver.
Dimming Driver
Structure of Motion Sensor
Settings
By selecting the combination on the DIP switch, motion sensor data can be set precisely for each specific application.
Detection area
Detection area can be reduced by
selecting the combination on the
DIP switches to fit precisely each
application.
Factory setting:
Hold-time
Refers to the time period the lamp
remains at 100% illumination after
no motion is detected.
Factory setting:
Stand-by period
Refers to the time period the lamp
remains at a low light level before
it completely switches off in a
long absence of people. When set
to Disable mode, the low light is
maintained until motion is detected.
Factory setting:
BRl823-B-D wiring with non-dimming ballast or LED driver.
Non-Dimming Driver
I
VI
I
3
Daylight Sensor
The sensor can be set to only allow
the lamp to illuminate below a defined
ambient brightness threshold. When
set to Disable mode, the daylight
sensor will switch on the lamp when
motion is detected regardless of
ambient light level. 150lux, 100lux,
50lux = twilight operation; 15lux,
5lux = darkness operation only.
NOTE: Daylight sensor is active
only when lamp totally switches off.
VII
Factory setting:
Stand-by DIM level
The low light level you would
like to have after the hold time
in a long absence of people.
I
Factory setting:
Publicidad
