Ryobi TS1144 Manual Del Operador página 12

FEATURES
PARTIAL SLIDING FENCE
The partial sliding fence on your compound miter saw has
SWITCH
been provided to help secure the workpiece when making TRIGGER
straight cuts.
The sliding feature makes it easy to adjust the position of
the partial fence. Loosen the fence screw before attempt-
ing to slide the partial fence. Once the desired position is
TRIGGER
determined, tighten the fence screw to secure.
LOCKOUT
LEVER
POSITIVE STOPS ON MITER TABLE
Positive stops have been provided at 0°, 15°, 22.5°, 31.6°,
and 45° on both the left and right side of the miter table.
SELF-RETRACTING LOWER BLADE GUARD
The lower blade guard is made of shock-resistant, see-
through plastic that provides protection from each side of
the blade. It retracts over the upper blade guard as the saw
is lowered into the workpiece.
SPINDLE LOCK BUTTON
See Figure 5.
SPINDLE
LOCK BUTTON
The spindle lock button locks the spindle stopping the blade
from rotating. Depress and hold the lock button while install-
ing, changing, or removing blade.
SWITCH TRIGGER
See Figure 5.
The saw will not start until you depress the trigger lockout
lever and squeeze the switch trigger. To prevent unauthor-
ized use of the compound miter saw, disconnect it from
the power supply and lock the switch in the OFF position.
To lock the switch, install a padlock (not included) through
the hole in the switch trigger and make certain the switch
is inoperable. If the switch is still operable with the padlock
installed, a padlock with a larger shackle diameter must be
used. Store the padlock key in another location.
PADLOCK
Fig. 5
12 - English