Kärcher K 2.360 Manual Del Usario página 7

Assembly
Mount loose parts delivered with appliance
prior to start-up.
Illustrations on Page 2
Illustration
 Attach the transport handle.
Illustration
 Insert the transport wheels and lock
them.
Illustration
 Insert holder for trigger gun.
Illustration
 Pull out the clamp for the high pressure
hose from the trigger gun.
Illustration
 Connect high pressure hose to trigger
gun.
 Push the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
Illustration
 Screw the coupling element to the wa-
ter connection on the appliance.
 Park the appliance on an even surface.
Illustration
 Connect the high pressure hose to the
high pressure connection of the appli-
ance.
 Insert the mains plug into the socket.
For connection values, see type plate/tech-
nical data.
Observe regulations of water supplier.
ATTENTION
Impurities in the water can damage the
high-pressure pump and the accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
For connection values, see type plate/tech-
nical data.
Illustration
 Screw the supplied hose coupling on to
the end of your water supply hose.
 Attach the water supply hose to the
coupling on the water connection.
 Connect the water supply hose to the
water supply.
 Completely open the water tap.
– 7
EN
Start up
Water supply
7