Operating Instructions - Dyna-Glo DGA480SSN Manual Del Usuario

OPERATING INSTRUCTIONS

LIGHTING THE GRILL
Before first use:
Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important
to clean your grill with heat. To do this, operate the grill for approximately 15 minutes with the lid closed
and the control knob in the highest position. This will clean the internal parts by burning off any residue
and odor from the manufacturing process.
If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF
the manual gas shutoff valve and then TURN OFF the control knob.
Do not lean over grill when lighting. Read instructions before lighting.
1. Check that the control knobs are in the
2. Open natural gas shutoff valve.
3. Open lid during lighting.
4. Push igniter down 3 to 4 seconds while turning right side control knob to the
burner should ignite.
If ignition does not take place within 5 seconds, immediately turn the control knob to the
position. Wait 5 minutes and repeat Step 4 above or refer to match lighting instructions below.
5. Repeat Step 4 above to ignite left side burner.
If the burner still does not light, check that the manual gas shutoff valve is open and follow the match
lighting instructions.
LIGHTING THE GRILL WITH A MATCH
1. Insert a match in the end of the match holder that is installed on the inside of the cabinet door.
2. Light the match.
3. Immediately place the lit match through the 0.75 inches (20 mm) hole on the side of the grill body,
nearest the left burner. Make sure the lit match is close to the burner ports.
4. Press in the control knob that operates the left burner and rotate counter-clockwise
position and burner should light immediately.
5. The other main control can now be turned on the
6. Adjust burners to desired cooking settings.
SHUTDOWN INSTRUCTIONS
1. Turn control knobs
2. Close manual gas shutoff valve.
3. Close lid.
Turn off manual gas shutoff valve when appliance is not in use.
CAUTION
WARNING
OFF position.
clockwise to the OFF position.
15
High position and will light via crossover port.
HIGH position. The
OFF
to High