Black+Decker BDCDHP220 Manual De Instrucciones página 7

aluminum foil, or any buildup of metallic particles should be kept away from charger
cavities. Always unplug the charger from the power supply when there is no battery
pack in the cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING:
attempt to open the battery pack for any reason. If the plastic housing of the battery pack
breaks or cracks, return to a service center for recycling.
Safety Warnings and Instructions: drills
WARNING
:
WARNING
:
Always expect the stall. Grip the drill firmly with two hands to control the twisting action
and prevent loss of control which could cause personal injury. If a stall does occur,
release the trigger immediately and determine the reason for the stall before re-starting.
fuNctIoNAl deScRIPtIoN
figure A
1. Trigger Switch
2. Forward/Reverse Button
3. Torque Adjust Collar
4. Dual Range Gear Selector
5. Keyless Chuck
6. Battery
7. Battery Release Button
8. LED Work Light
9. Bit Tip Holder
operating Instructions
Installing and Removing the Battery Pack from the tool
cAutIoN
:
Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
to INStAll BAtteRy PAck: Insert
battery pack (6) firmly into tool until an
audible click is heard as shown in figure B.
Ensure battery pack is fully seated and fully
latched into position.
to ReMove BAtteRy PAck: Depress
the battery release button (7) as shown in
figure c and pull battery pack out of tool.
Shock hazard. Do not allow any liquid to get inside charger. Never
Before using tool, read all instructions and cautionary markings on tool.
Drill may stall (if overloaded or improperly used) causing a twist.
A
5
8
9
7
B
7
3
4
2
1
6
C