Stenner Pumps S FIXED SERIE Manual De Instalación Y Mantenimiento página 33

TUBE REPLACEMENT
INSTALL THE TUBE/EXPAND THE ROLLER ASSEMBLY
H Place new tube
Cover Feet
I Install cover feet first
J Remove cover
K Invert cover
Center of Roller Assembly Cover Feet
L Align cover feet near bottom
USA and Canada 800.683.2378, International 904.641.1666
1. Ensure the power to the pump is off and the input
2. Install the tube. Illustration H
3. Place the tube housing cover (feet first) on the tube
Cover
4. Fixed: Plug pump in.
3 Lugs
5. Unplug the power cord.
6. Remove the tube housing cover and flip to use as a
7. Align the center of the inverted cover with the
continued
signal is disconnected.
S3F & S3V Models
Place the new tube in the pump head and use
your fingers to center it on the rollers. Go to #3.
S4F & S4V Models
- Place the new tube in the pump head.
- Use your fingers to center the tube on the rollers.
Go to #3.
housing, affix the front of the latches to the cover
lip and then press the latches back to secure. Be
sure the cover is seated with the sleeve bearing on
the shaft and is flush with the housing before
latching. Illustration I
Variable: Set potentiometer to 100%.
With cover latched, run the roller assembly in the
collapsed position for four minutes.
tool in the next step. Illustration J and K
center of the roller assembly so that the three holes
on the face of the cover align with the three knurled
lugs on the roller assembly. Position the cover feet
near the bottom. Illustration L
IMPORTANT: DO NOT
TWIST THE TUBE during
installation. To ensure it
doesn't twist, keep the
tube positioned so the
printed description stays
aligned along the length
of the tube.
S Fixed & Variable Series
33