G Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; Ec Declaration Of Conformity - SUHNER ABRASIVE LLG 4 Documentación Técnica

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LLG
4.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for purposes for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with burrs and abrasives. The
machine is intended exclusively for 2-hand working op-
erattions.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner GmbH, Trottäcker 50, D-79701 Bad Säck-
ingen, hereby declares under sole responsibility that
the product with the serial or batch no. (see reverse
side) complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: M. Voyame. D-Bad Säckingen,
08/2017.
M. Voyame/Division manager
2. c
2.1 p
rior to tAKing the mAchine into serVice
Fitting of hose coupling (inside diameter min. 7
mm, available as optional accessory, item no. 908
057, type DN 8). Use oiled compressed air (see
also air quality under section 2.3). Observe national regu-
lations.
2.2 t
AKing the mAchine into serVice
2.2.1 t /t
urn on urn off
12
S
oteS on afety
ommISSIonIng
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever switches the machine OFF.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load
Air consumption at idling
No-load speed
Wheel Ø
Chuck Ø
Setting oiler idle
Sound pressure level EN ISO 15744 77dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight
2.4 o
perAting conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. h
andlIng
3.1 f BsgV 35
itting of
Release fixation with hook wrench no. 30/32. Screw in
adapter and tighten down (for torque and data on Loctite
please refer to the page 2/3).
max. 6.3bar
900W
3
1.1m /min
3
0.6m /min
-1
4'000min
max. 200mm
max. 10mm
2-3 drops/min
2 2
4.9m/s , K=2.4m/s
3/4/4
1.700kg
/o
peratIon
AdApter