Preparation; Assembly Instructions - Kobalt 0300841 Manual Del Usuario

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time: 5 minutes
Tools Required for Assembly (not included): 11/16 in. Open Wrench or Adjustable Wrench.

ASSEMBLY INSTRUCTIONS

1. Removable handle assembly
• Insert handle (K) into the fixed sleeves. Align the tapped
holes (K1) with the holes on the sleeve.
• Fasten the handle to the sleeve using the screws (AA).
Hardware Used
AA
M8 × 15 Screw
2. Wheel assembly
• Insert the bolt (BB) through one of the wheels (L).
• Insert the bolt (BB) through the bracket on the bottom of the
tank assembly. Slide on washer (CC), spring washer (DD)
and tighten the nut (EE). Repeat this step for the second wheel.
• Once assembled, roll the air compressor to test the operation
of the wheels, and then snap on the wheel caps (FF).
Periodically check to ensure that the wheels and the hardware
are secure.
Hardware Used
BB
M10 Bolt
CC
Ø10 Washer
DD
Ø10 Spring Washer
EE
M10 Nut
FF
Wheel Cap
x 2
x 2
x 2
x 2
x 2
x 2
7
1
AA
K
K1
2
EE
CC
DD
L
BB FF
M