Maintenance; Mantenimiento; Entretien - Delta 1980T-DST Serie Guía Del Comienzo Rápido

Maintenance

Mantenimiento

Entretien

1
2
Maintenance
Timeout Feature:
Water will stop flowing 4 minutes after the fau-
cet is last touched.
If faucet exhibits very low flow:
A. Remove and clean Aerator (1) with supplied
wrench (2).
B. SHUT OFF WATER SUPPLIES. Replace
valve cartridge (5). When reinstalling parts,
make sure bonnet nut (6) is tightened
securely with a wrench.*
If faucet leaks from under handle:
Remove handle and unthread trim sleeve (7).
Using a wrench, ensure bonnet nut (6) is tight.
If leak persists–SHUT OFF WATER
SUPPLIES. Replace valve cartridge (5). When
reinstalling parts, make sure bonnet nut (6) is
tightened securely with a wrench.*
If faucet leaks from spout outlet–SHUT OFF
WATER SUPPLIES. Replace valve cartridge
(5). When reinstalling parts, make sure bonnet
nut (6) is tightened securely with a wrench.*
* WARNING: Failure to securely tighten
bonnet nut with a wrench could result in
water damage.
Note: A small amount of water may run out the spout
or drip for a very short period after the faucet is shut
off. This is a natural occurrence caused by the long
flexible hose.
Note: Do not attempt to disassemble cartridge (5).
There are no repairable parts inside.
If touch function stops working after service to
faucet or connections:
Reset system by removing batteries for 30 seconds
then reinstalling.
LED Guide
If LED (8) is:
Solid Blue - Solenoid valve is open, water
temperature is less than 80
Solid Magenta - Solenoid valve is open, water
temperature is between 80
°
(43 C).
Solid Red - Solenoid valve is open, water
temperature is greater than 110
3 red flashes before solenoid opens or closes -
replace batteries.
36
1/8"
7
6
5
8
° ° ).
F (27 C
° °
C) and 110
F (27
° °
F (43 C).
°
F