LG LSCG366 Serie Manual De Usuario página 13

7. ADJUST THE SURFACE BURNER LOW FLAME
(SIMMER) SETTING
For all surface burners except for the center
burner
1. Light all surface burners except for the center
burner.
2. Turn the knob on the burner being adjusted to LO
(LOW).
3. Remove knob.
4. Insert a small, flat bladed screwdriver into the
valve stem as shown in Fig.2.
5. Turn the adjustment screw until the flame reaches
the desired size.
6. Replace the knob.
Center adjustment screw
Fig. 2
7. Test The Flame Stability.
Test 1 :
• Turn the knob from HI to LOW quickly.
• lf the flame goes out, increase the flame size a
nd test again.
Test 2 :
• With the burner on a LOW setting, open and
close the oven or cabinet door quickly.
• If the flame is extinguished by the air currents
created by the door movement, increase the
flame height and test again.
8. Repeat steps 1 - 6 for each surface burner except
for the center burner.
Only For the center burner
1. Disconnect power to appliance.
2. Remove grates, burners caps, burner heads and
knobs.
3. Remove all the screws on the cooktop with a
philips screwdriver.
4. Remove the cooktop by lifting it up.
5. Remove LED lamp module of the center valve by
unclipping. In this case, the ignition switch should
be positioned properly.
6. Replace the cooktop and secure the screws of the
cooktop.
I N S TA L L AT I O N I N S T RU C T I O N S
7. Position center burner head, center burner cap,
center grate, and center knob.
8. Connect power to the appliance.
9. Light center burner.
10. Turn the knob on the burner being adjusted to LO
(LOW).
11. Remove knob.
12. Using a small, flat bladed screwdriver insert into
the hole next to the valve stem to adjust the outer
flame as shown in Fig.3.
13. Turn the adjustment screw until the flame
reaches the desired size.
14. Replace the knob.
Adjustment screw next to the valve shaft
15. Test The Flame Stability.
Test 1 :
• Turn the knob from HI to LOW quickly.
• If the flame goes out, increase the flame size
and test again.
Test 2 :
• With the burner on a LOW setting, open and
close the oven or cabinet door quickly.
• If the flame is extinguished by the air currents
created by the door movement, increase the
flame height and test again.
16. After setting the low flame, turn off the burner.
17. Disconnect power to the appliance.
18. Remove knob, grate, burner cap, and burner
head.
19. Remove all screws from the cooktop.
20. Remove the cooktop by lifting up.
21. Replace the center LED lamp module.
22. Replace the cooktop and secure all screws.
23. Replace burner heads, burner caps, grates and
knobs.
24. Connect power to appliance.
Fig. 3
13