Metabo HPT RH 650V Manual De Instrucciones página 11

2. Softening adhesive (Fig. 7)
Use nozzle (flat) or nozzle (round) to
soften the surface and make it easy to
peel, and then pull up one of the edges,
blow heat underneath it and gently peel
it off so that none of the adhesive
remains.
Nozzle (Round)
3. Heat wrapping (Fig. 8)
Use nozzle (flat) to heat-wrap shrink film
and tubes. The material will change color
or crack if hot air is blown onto it from a
close distance, so maintain an
appropriate distance while monitoring
progress.
Nozzle (Plane)
4. Forming resin pipes (Fig. 9)
Use nozzle (curved surface) to evenly
heat the circumference of the resin pipe.
To prevent the inside of the pipe from
narrowing when bending it, etc., pour
sand inside, block both ends and then
gently bend it.
Fig. 7
Fig. 8
5. Removing putty from window
frames (Fig. 10)
Use nozzle (glass protector) to soften the
putty with heat, and then remove the
putty with the scraper supplied.
Note that glass may crack if heat is
continually applied to it.
Nozzle (Glass protector)
Scraper
Fig. 10
6. Defrosting water pipes (Fig. 11)
Use nozzle (curved surface) to heat the
frozen area from the edge to the center.
Do not mistake water pipes for glass
pipes.
Take care to avoid damaging frozen resin
areas on water pipes.
Nozzle
(Curved surface)
Fig. 11
English
Nozzle
(Curved surface)
Fig. 9
11