Picture Position Adjustment - Eiki LC-XNB2 Manual De Instrucciones

COMPUTER MODE
The Auto Image function is provided to automatically adjust Fine
sync., Total dots, and Picture Position for most computers.
Press the MENU button and the ON-SCREEN MENU will
1
appear. Press the POINT LEFT/RIGHT buttons to select
AUTO IMAGE
Another dialog box AUTO IMAGE Menu will appear.
Move the arrow to an item that you want to adjust by pressing
2
the POINT UP/DOWN button. Change the setting On or Off by
pressing the SELECT button.
Fine sync.
Adjust the picture as necessary to eliminate flicker from the display.
This item can be adjusted manually. (Refer to page 27.)
Total dots
The number of the total dots in one horizontal period. This item can
be adjusted manually. (Refer to page 27.)
Position
Adjustment of the position of the image. This item can be adjusted
manually. (Refer to page 28.)
Move the arrow to "Go!" and press the SELECT button to start
3
the Auto Image function.
This adjustment can be executed by pressing AUTO IMAGE
button on the Top Control and the Remote Control Unit.
Stored
Go!
Quit
NOTE : The Fine sync., Total dots, and Picture Position of some
computers may not be fully adjusted with the Auto Image
Function. In that case, manual adjustment is required to
make fine image. (Refer to page 27 to adjust "Fine sync." or
"Total dots" and page 28 to adjust Picture Position.)
The position of the image can be adjusted vertically and horizontally through PICTURE POSITION
ADJUSTMENT.
GB
Press the MENU button and the ON-SCREEN MENU will
1
appear. Press the POINT LEFT/RIGHT buttons to select
POSITION
POSITION dialog box will appear.
Move the image by pressing the POINT UP / DOWN / RIGHT /
2
LEFT buttons.
To cancel POSITION mode, press the any buttons except SELECT,
RIGHT CLICK, POINT, PAGE
position previously adjusted, press NORMAL button.
28
AUTO IMAGE FUNCTION
and press the SELECT button.
Stores the On/Off setting of each item.
Starts the Auto Image Adjustment.
Closes the AUTO IMAGE ADJUSTMENT Menu.

PICTURE POSITION ADJUSTMENT

and press the SELECT button. The PICTURE
/ or LASER button. To recall the
Starts the adjustment
on the item set to "On".
Close the PICTURE IMAGE
ADJUSTMENT Menu.
PICTURE POSITION
Press the POINT UP /
DOWN / RIGHT / LEFT
buttons to move the image
Move the arrow to
the item and then
press the SELECT
button.
dialog box