Smartmedia And Pc Card Adapter - Eiki LC-XNB2 Manual De Instrucciones

MCI MODE
SmartMedia and PC Card Adapter are provided with this LCD projector. SmartMedia can be used as a PC card
conforming to the PC Card Standard-ATA by combining with PC Card Adapter.
INSTALL
Insert SmartMedia fully into PC Card Adapter. Make sure EJECT
button pops out.
NOTE : The front side of SmartMedia has Contact Area on its
surface.
The front side of PC Card Adapter has Eject button on the
left side of the slot.
Do not insert SmartMedia in the reverse. The card and the
data can be damaged.
REMOVE
To remove SmartMedia, fully press in the EJECT button. The card
pops out, then take out the card.
NOTE : Do not pull SmartMedia by force. It may damage
SmartMedia or PC Card Adapter.
THE DATA STORED ON THE MEMORY CARD (SMARTMEDIA OR PC CARD) MAY BE DAMAGED OR
LOST BECAUSE OF THE DAMAGE OF THE MEMORY CARD OR THE ACCIDENTAL ERASURE. IT IS
RECOMMENDED THAT ANY IMPORTANT DATA SHOULD BE COPIED ONTO SEPARATE MEDIA,
SUCH AS A FLOPPY DISK, A HARD DISK, OR A MO DISK. WE SHALL NOT BE LIABLE FOR ANY
DAMAGE OR LOSS OF PROFITS ARISING FROM THE LOSS OF DATA BECAUSE OF THE ACCIDEN-
TAL OPERATION AND THE DAMAGE OF A MEMORY CARD OR APPLIANCES. REFER TO OWNER'S
MANUAL OF MEDIA CARD IMAGER FOR OPERATING THE SOFTWARE.
GB
38

SMARTMEDIA AND PC CARD ADAPTER

INSTALL / REMOVE THE SMARTMEDIA
PC Card Adapter
(supplied)
SmartMedia
(supplied)
EJECT button
IMPORTANT NOTE