Storage - Scheppach MR196- 61 Traducción De Las Instrucciones Originales De Funcionamiento

Pull off the spark plug boot with a twist. Remove the
spark plug (23) with a spark plug wrench.
Using a feeler gauge, set the gap to 0.75 mm( 0.030").
Refit the spark plug (23)taking care not to overtighten.
Replace fuse (fig. 34)
• The electrical start is protected with a 10 A fuse.
• Never use another fuse or bypass the fuse.
Charge the battery (fig. 29)
The battery is charged during operation. In any case,
frequent starting may make it necessary to charge
the battery with the included charging device (f):
• Plug the connector into the charging socket (7) and
the charging device (f) into a plug socket. 230 V
50 Hz
• Charge the battery for min. 5 hours.
Charge the battery with a car charging device
(fig. 30 + 31)
• You may also charge the battery with the included
charging cable (m) on an industry-standard car
charging device for 12 V lead batteries.
• Unplug the battery in this case (fig. 15).
• Connect the included charging cable (m) to the bat-
tery and connect the black cable with the - pole and
the red cable with the + pole of the charging device
(fig. 30 + 31).
Attention! Never exchange the + and - poles.
Always store the lawnmower with a fully loaded bat-
tery.
Tyre pressure:
Check the tyre pressure prior to starting!
The correct tyre pressure is 1.8 bar in the front wheels
and 1.3 bar in the rear wheels.
Important: If the tyre pressure is too low, the risk of
damage to the valves and therefore the hoses in-
creases.
Repairs
After any repair or maintenance work, check that all
safety-related parts are in place and in proper work-
ing order. All parts which may cause injury must be
kept where they are inaccessible to children or oth-
ers.
Important: In accordance with product liability legis-
lation we are not liable for any damages caused by
improper repairs or the use of spare parts that are not
original spare parts or parts approved by us.
In addition, we are also not liable for any damages
arising from improper repairs. Such work should be
performed by a customer services workshop or au-
thorized specialist. The same applies to accessory
parts.
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Important hint in case of sending the equipment
to a service station:
Due to security reasons please see to it that the
equipment is sent back free of oil and gas!
Ordering replacement parts
Please quote the following data when ordering re-
placement parts:
• Type of machine
• Article number of the machine
Spare parts/accessories
Lawn mower blade - Article no.: 7911200616
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables. Wear parts*: Spark plug, air filter, pet-
rol filter, blade, v-belt, battery, blade, tyres
* Not necessarily included in the scope of delivery

10. Storage

Storage for prolonged periods without operation
Allow the engine to cool before storing the machine in
an enclosed space.
Store the ride-on mower with empty fuel tank and the
fuel reserve in a lockable and well-ventilated room.
Never store the machine with petrol in the fuel tank in-
side a building in which the petrol fumes could come
into contact with naked flames or sparks.
If the tank has to be emptied (e.g. immobilisation be-
fore the winter break), the fuel tank must be emptied
out of doors only (empty the tank by running the en-
gine out of doors, for example).
Store the machine in good operational condition.
The ignition key must always be removed and kept in
a safe place, to prevent unauthorised or improper use
by children or other persons.
Thoroughly clean the ride-on mower before storage
(e.g. winter break). Dry grass residues and leaves
near to the muffler may ignite.
Danger of combustion!
Allow the machine to cool down completely before
covering it.
Perform all the necessary maintenance operations
before storing the machine.
GB | 49