Mediclinics M14A-UL Manual De Instalación Y Utilizacion página 11

INSTALLATION AND MAINTENANCE BOOK (TECHNICAL STAFF)
Introduction.
'Dualflow Plus' family of hand dryers offers the technical features as follows.

Automatic operation. Drying cycle starts when putting hands in. Two couple of IR
sensors detect hands introduction.

The hand dryer includes a grounding lug, which must be connected to ground.

Drying process is based on powerful air curtains which remove water from hands.

These hand dryers include a Ni-Cr thermally protected heating element and are
protected by a thermal limiter.

Speed of air can be adjusted in order to achieve an optimum balance between drying
power and noise level.

Light leds on top supply some information referred to the status of hand dryer.

Maximum time of continuous operation is T max = 30 sec.

Water from hands is collected in an internal tank which may be emptied.
Installation.
ONLY A QUALIFIED TECHNICIAN CAN INSTALL, ADJUST AND MAINTAIN THIS HAND
To install the hand dryer follow the pictures contained in the figure 2.
The hand dryer must be fitted to the wall by using the upper metal plate (support) which is
supplied.
After fitting the metal plate, the hand dryer should be hung on it. The lower screws fits safely the
appliance to the wall. So, to assemble the hand dryer the following steps must be done.

Make five 8 mm (0.31") diameter drill holes in the wall using the provided template (1).

Clean the dust away and insert the wall plugs.

Screw the upper plate to the wall (2).

Plastic covers which protect the terminal block (inlet power supply) must be removed (3).

The hand dryer should be hung on the metal support which has been fitted to the wall (4).
READ AND SAVE THESE INSTRUCTIONS
DRYER.
-11-