Fixation Of The Projector; Bottom Surface - JVC DLA-RS65 Manual De Instrucciones

Proyector d-ila
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Preparation
2
About installation (Continued)

Fixation of the projector

Measures to prevent the unit from toppling or dropping should be taken for safety reasons and
accident prevention during emergencies including earthquakes.
When mounting this unit on a pedestal or ceiling, remove the 4 feet on the bottom surface and
use all the 4 screw holes (M5 screws) to mount.
Ceiling
Precautions for Mounting
Special expertise and techniques are required for
mounting this unit. Be sure to ask your dealer or a
specialist to perform mounting.
Depth of the screw holes (screw length) is 23
mm. Use screws shorter than 23 mm but longer
than 13 mm.
Using other screws will result in
malfunctioning or cause the unit to drop.
When mounting to a pedestal, ensure
sufficient space (foot height of 10 mm or
higher) around the unit so that the air inlets
are not blocked.
Do not tilt this unit more than ±5 degrees
from side to side when using.
24

Bottom Surface

4 locations
Air inlets
Regardless whether the unit is still under
guarantee, JVC is not liable for any product
damage caused by mounting the unit with non-
JVC ceiling fittings or when the environment is
not suitable for ceiling-mount.
When using the unit hanging from a ceiling,
pay attention to the surrounding temperature.
When a heater is in use, temperature around
the ceiling is higher than expected.

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Dla-rs55Dla-rs45

Tabla de contenido