Before Use - Metabo HPT WR 18DSHL Instrucciones De Seguridad Y Manual De Instrucciones

English
CAUTION
● When the battery charger has been continuosly
used, the battery charger will be heated, thus
constituting the cause of the failures. Once the
charging has been completed, give 15 minutes
rest until the next charging.
● If the battery is rechraged when it is warm due
to battery use or exposure to sunlight, the pilot
lamp may light in green.
The battery will not be recharged. In such a case,
let the battery cool before charging.
● When the pilot lamp fl ickers rapidly in red (at
0.2–second intervals), check for and take out
any foreign objects in the charger's battery
installation hole. If there are no foreign objects,
it is probable that the battery or charger is
malfunctioning. Take it to your authorized
Service Center.

BEFORE USE

Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
OPERATION
1. Selecting the socket matched to the bolt
Be sure to use a socket which is matched to the bolt
to be tightened. Using an improper socket will not only
result in insuffi cient tightening but also in damage to
the socket or nut.
A worn or deformed hex. or square-holed socket will
not give an adequate tightness for fi tting to the nut
or anvil, consequently resulting in loss of tightening
torque.
Pay attention to wear of socket hole, and replace
before further wear has developed.
Matching socket and bolt sizes are shown Tables 6.
The numerical value of a socket designation denotes
the side-to-side distance (H) of its hex. hole.
2. Installing a socket (Fig. 6, 7-1)
Align the plunger located in the square part of the
anvil with the hole in the hex. socket. Then push
the plunger, and mount the hex. socket on the anvil.
Check that the plunger is fully engaged in the hole.
When removing the socket, reverse the sequence.
12
Hexagonal socket
Hexagonal socket
3. Retaining ring type (Fig. 6, 7-2)
(1) Align the square portions of the socket and the anvil
with each other.
(2) Make sure to fi rmly install the socket by pushing it all
the way into the anvil.
(3) When removing the socket, pull it out of the anvil.
Hexagonal socket
CAUTION
● Please use the
which are listed in the operations manual and
metabo HPT's catalog. Accidents or injuries
could result from not doing so.
● Make sure to fi rmly install the socket in the anvil.
If the socket is not fi rmly installed it might come
out and cause injuries.
4. Confi rm that the battery is mounted correctly
5. Switch operation
The switch in this machine functions as a motor switch
and rotational direction selector switch. When the
switch is set to indicated on the handle, the motor
rotates clockwise to tighten the bolt. When the switch
is set to , the motor rotates counterclockwise to
Groove
Anvil
Fig. 6
Hole
Plunger
Anvil
Fig. 7-1
Hole
Anvil
Fig. 7-2
designated attachments