Bras MAESTRALE JOLLY 5.1 Manual De Instrucciones página 13

5. 3. 1 DISASSEMBLY
ATTENTION
Before any disassembly and/or cleaning
procedure make sure that the dispenser is
disconnected from its power source by
unplugging it.
1
Remove cover from the bowl.
2
Remove the empty bowl by lifting pulling
lever (1) and its front side (faucet side) up and
off bowl gasket (see figure 2).
3
Remove the bowl gasket.
4
Remove the pump impeller from its location.
5
Pinch tube faucet: push the dispensing
handle (1) and take the pinch tube off from its
seat (2) (see figure 3).
6
Gravity faucet: extract the piston and then
remove the dispensing handle (see figure 4).
figure 2
figure 3
figure 4
7
Slide drip tray out and empty it.
5. 3. 2 CLEANING
ATTENTION
Before any disassembly and/or cleaning
procedure make sure that the dispenser is
disconnected from its power source.
IMPORTANT
Do not attempt to wash any machine com-
ponents in a dish washer.
1
Prepare at least two gallons of a mild
cleaning solution of warm (45-60 °C 120-140 °F)
potable water and dishwashing detergent. Do not
use abrasive detergent.
Important: if present, follow label directions, as
too strong a solution can cause parts damage,
while too mild a soluti on will not provide
adequate cleaning.
IMPORTANT
In order to prevent any damages to the
dispenser use only a detergent suitable
with plastics parts.
2
Using a brush, suitable for the purpose,
thoroughly clean all disassembled parts in the
cleaning solution.
ATTENTION
When cleaning the machine, do not allow
excessive amounts of water around the
electrically operated components of the
unit. Electrical shock or damage to the
machine may result.
3
Do not immerge the lighted top covers in
liquid. Wash them apart with the cleaning
solution. Carefully clean their undersides.
4
In the same manner clean the evaporator
plates using a soft bristle brush.
5
Rinse all cleaned parts with cool clean water.
13