Di4 Vapore Stiro Performance 3200 Manual Del Usuario página 19

Allow the iron to heat up until the indicator light becomes fixed.
Unplug the steam iron.
Holding the iron horizontally over the sink and press the button of Self clean, in case if not have this
button change the steam control to the maximum position.
Boiling water and steam will be ejected from the holes in soleplate with impurities washed out Move
the iron over an old (preferably) piece of cloth. This ensures that the soleplate will be dry during storage.
Is recommended to do the self-cleaning at least every two weeks.
ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale build-up in the
plate. The resin filter is permanent and does not need replacing.
Please note: Do not use chemical additives, scented substances or decalcifies. Failure to comply
with the above-mentioned regulations leads to the loss of guarantee.
AUTO SHUT-OFF
An electronic safety device will automatically switch the heating element off if the iron has reached
the temperature selected and the handle sensor is not touched for more than 10 seconds approxima-
tely in a horizontal position. If in a vertical position, this will happen after 10 seconds approximately,
too, provided selected temperature is reached and handle sensor is not touched.. To indicate that the
heating element has been switched off, the auto-off pilot light will start blinking.
When picking up the iron again, the auto-off pilot light will turn off. The power pilot light will turn on.
This indicates that the iron is heating up again.
Wait for the power pilot light to become fixed, then the iron is ready for use.
SENSE TECHNOLOGY
The iron handle incorporates a sensor that, when the variable steam is selected, will turn on the va-
riable steam function while the hands touches the handle form the upper part. If the iron is not tou-
ched the variable steam function will be stopped.
INJECTION STEAM
The appliance has an injection steam system that injects water to the soleplate in order to facilitate
a greater penetration of steam into the garments. You will notice this function as a small vibration
when product is working under steam ironing function.
19