Makita DUM604 Manual De Instrucciones página 11

4. Apply a small amount of grease to the periphery
of the crank. Attach the crank to the pins with the small
and large rounds facing up.
► 1 . Crank
5. Adjust the blades and base plate so that the hole
in the base plate and the two protrusions on the blades
are lined up.
6. Turn the shear blades upside down and install
them so that the pins on the tool fit in the hole on the
base plate. Make sure that the shear blades are fixed
securely in place.
7. Place the undercover so that
cover is aligned with
1
8. While pressing the undercover, turn the under-
cover clockwise until
with
9. Make sure that the lock lever fits in the groove on
the undercover.
► 1 . Lock lever
CAUTION:
ing the undercover.
10. Remove the blade cover, and then turn on the tool
to check that it works properly.
NOTICE:
erly, the blades are not engaging the crank prop-
erly. Remove the blades and install them again.
11 ENGLISH
on the lock lever.
on the undercover is aligned
on the lock lever.
1
Never use the tool without install-
If the shear blades do not operate prop-
on the under-