Assembly; Unpacking And Checking Contents - Bosch CM10GD Instrucciones De Funcionamiento Y Seguridad

BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 10
Unpacking the Miter Saw – When removing this tool
from packaging materials, reach down to the two side
carry-handle locations and slowly lift until it clears the
package.
WARNING
any component of the mechanism support
system.
This symbol is placed at various
locations on the tool to warn the user
of pinch-point areas.
Loose Parts - 1 of each shown
10mm Flat Washer
Bevel Lock Lever
6mm Flat Washer
6mm Lock Nut
10 mm Socket Tool
6/4mm Hex Key

Assembly

Unpacking and Checking Contents

To avoid severe pinching, never
lift or move this saw by gripping
Checking Contents in package – Open the top of
the package and look for the included loose parts.
Refer to the diagram below.
Some small parts such as the bevel lock lever and
miter lock knob require attachment to the tool before
it is ready for use – See "Attaching Loose Parts" on
page 12.
To avoid possible injury, always
WARNING
disconnect plug from power
source before
adjustments or repairs.
Check off for each part
Workpiece Clamp
Dust Bag
10.
performing any assembly,
Manual
Operating/Safety Instructions
Miter Lock Knob