Commissioning - Solter aeroprocess 4110 DV Manual De Instrucciones

COMMISSIONING

2 - Make all connections between the equipment and the winder. You must select the polarity depending on the type of
wire that you will use. However, gas tube and control cable always have to be connected in the same place (1-2). The
order of connection is always the same, the power cord first, second, the gas connector and finally, the control cable
The standard AEROFEED winder comes with a 1.7m cable (73362). If desired, the same cable is available with lengths
of 5m and 10m.
The various connections available are shown below:
NORMAL CONNECTIONS
REFRIGERATION CONNECTIONS
1,7m DW AEROFEED CONNECTION
5m DW AEROFEED CONNECTION
10m DW AEROFEED CONNECTION
3 - Connect the ground clamp as close as possible to the work piece and connect the other side of the cable to the
machine (in the desired position depending on the polarity). The contact surface with the work piece should be as large
as possible. Make sure the surface is completely clean and free of paint and rust. The following table shows the cable
1 - Unscrew the metal bracket behind the plastic rolls holder. Through this bracket,
you must pass the interconnecting wiring between the power unit and the
AEROFEED unit. This clamp secures and maintains the connection aligned.
Positive connection
This type of connection is the most common for different types of wire. The power
cable is connected to the positive pole and the earth clamp to the negative pole.
Negative connection
This type of connection is less frequent. It is used for tubular steel wires without gas
or with gases of basic type. The power cable is connected to the negative pole and
the earth clamp to the positive pole.
You are recommended to see the polarity specifications given by the wire
manufacturer, as these may vary
1,7m AEROFEED CONNECTION
5m AEROFEED CONNECTION
10m AEROFEED CONNECTION
73362
73363
73364
73365
73366
73367
27