Transport And Installation Of The Welding Machine; Use Of Electric Generators; Description Of The Items Of Equipment - Solter aeroprocess 4110 DV Manual De Instrucciones

TRANSPORT AND INSTALLATION OF THE WELDING MACHINE

Impacts should be avoided during transport of the machine. The transport position must be as indicated on the
packaging. The machine must be located in a dry, well-ventilated area and away from the welding station, to prevent
metal dust entering the welding machine. The machine must be installed on a horizontal surface with a maximum
gradient of 10°. Place the machine away from water outlets. The machine must be connected to an electrical box,
which should consist of a circuit breaker and an automatic switch. The circuit breaker protects people from direct or
indirect contact with electrical parts. The automatic switch must be chosen according to the equipment nameplate. A
switch with an intensity/time ratio of the slow type (D curve) is recommended to prevent false triggering.
HANDLING OF THE MACHINE
To handle the power unit always use the front and rear handles. If you have the UTS 200 transport unit, check that all
couplings are properly fixed. To handle the machine once it is located in the transport unit, DO NOT use the upper
handles of the power unit. Handle the whole machine using eye bolts screwed to the base of the transport unit.

USE OF ELECTRIC GENERATORS

The machines are prepared to work with an electric generator. However, these generators must meet certain
requirements. It is recommended to use three-phase generators with a constant power of at least 25KVA. If the
generator does not have enough power or the output voltage is outside the operating limits of the machine, the stability
of the welding arc and, therefore, the quality of the weld joint could be affected. In the worst case, it can even cause
damage to the machine. Do not use more than one welding machine with the same generator at the same time.
Sudden changes in charge level may affect the stability of the welding arc.

DESCRIPTION OF THE ITEMS OF EQUIPMENT

1 - Cooler switch
2 - Refrigerator LED indicator
3 - Positive pole connector
4 - Gas connector
5 - Aerofeed input connector
6 - Negative pole connector
7 - Connection to three-phase power network
8 - Main switch
9 - 2A fuse
10 - Gas input
26