Operating The Menu - Solter aeroprocess 4110 DV Manual De Instrucciones

Data menu
Menu for welding
parameters
Enabled
function
Software version

OPERATING THE MENU

Worked time Worked time
Number of selected Number of selected
program
Disabled
function
Firmware release Firmware release
of the user interface of the user interface
Program access
Factory
settings
Confirm
Power unit
firmware release database version database version
To access the machine menu press key (17). access the machine menu press key (17).
The first option of SET menu is displayed. From this point, with The first option of SET menu is displayed. From this point, with
the main selector (19), select the desired menu. the main selector (19), select the desired menu.
Once the desired option appears, press the main selector to Once the desired option appears, press the main selector to
access the different parameters of the selected menu, allowing access the different parameters of the se
to check the value or change it (press the main selector to to check the value or change it (press the main selector to
modify the value (flashing mode) + press again the main modify the value (flashing mode) + press again the main
selector to confirm the new value). To exit the menu from any selector to confirm the new value). To exit the menu from any
position, use the 17 key.
The changes made are automatically saved and will be in The changes made are automatic
effect until they are changed. If we want to save the data in a effect until they are changed. If we want to save the data in a
given program, proceed according to the operation of the given program, proceed according to the operation of the
program memories
Save program Save program
in memory
Program
Functions
Reset of consumed
Cancel
MIG-MAG SYN MAG SYN
Load program
from memory
Consumed
wire
wire counter
31