Technical Data; Transportation In Vehicle; Starting Operation; High-Pressure Hose, Spray Gun And Separating Oil - WAGNER PROSPRAY 20 Instrucciones De Uso

DESCRIPTION OF UNIT / STARTING OPERATION
4.5

TECHNICAL DATA

Voltage
Max. current consumption
100-110 VAC~
220-240 VAC~
Rated input of device
Power Cord
Max. operating pressure
Max. volume flow
Volume ow at 12 MPa (120 bar) with water
Max tip size
Max. temperature of the coating material
Max viscosity
Weight
Special high-pressure hose
6,35 mm, 15 m - 1/4" - 18 NPSM
Dimensions (L X W X H)
Vibration
Spray gun does not exceed 2.5m/s
Max sound pressure level
* Place of measurement: 1 m distance from unit and
1.60m above oor, 12 MPa (120 bar) operating pressure,
reverberant oor
4.6

TRANSPORTATION IN VEHICLE

Secure the unit with a suitable fastening.
10
100-110 VAC~, 50/60 Hz or
220-240 VAC~, 50/60 Hz
11.0 A
5.9 A
900 W
6 m long, 3 x 1.5 mm²
214 bar (21.4 MPa)
2.0 l/min
1.60 l/min
0.021 inch – 0.53 mm
43°C
20.000 MPa·s
15.2 kg
480 x 360 x 405 mm
80 dB*
5

STARTING OPERATION

5.1
HIGH PRESSURE HOSE, SPRAY GUN AND
SEPARATING OIL
1. If equipped, screw the pressure gauge (1) to the coating
material outlet (Fig. 2, Item 2).
2. Screw the high-pressure hose (3) to the coating material
outlet (Fig. 2, Item 4).
3. Screw the spray gun (5) with the selected tip onto the
high-pressure hose.
4. Tighten the union nuts at the high-pressure hoses rmly
so that coating material does not leak.
1
4
5. Fill the oil cup with EasyGlide (Fig. 3). Do not use too much
EasyGlide, i.e. ensure that no EasyGlide drips into the
coating material container.
EasyGlide prevents increased wear and tear to
the packings.
Attention
2
2
3
ProSpray 20
5