Makita PM7650H Manual Del Propietario Y De Seguridad página 13

To install the deflector (1), mount the deflector on the top nozzle so that the "I" mark
(3) on it is aligned with the "I" mark (4) of the top nozzle (2).
Secure the deflector by turning it fully clockwise.
To remove the deflector, follow the above procedure in reverse.
Changing the nozzle to a different-amount-solution-discharge nozzle (optional accessory)
When a different amount of solution needs to be sprayed, change the nozzle to one with a different discharge hole.
NOTE: Standard nozzle may differ from country to country.
Type of nozzle
Type of nozzle Hole diameter
Nozzle 4.5 4.5 mm
Nozzle 0.8 0.8 mm
Nozzle 0.7 0.7 mm
Nozzle 0.5 0.5 mm
* The discharge rate shown in the table is a guide line in case of use of water only. It varies by the liquid being used.
Appearance of Nozzle
Nozzle 4.5
Brass
Big hole
To replace the nozzle:
1. Remove the screw (1) from the second nozzle (2) and then remove the top
nozzle (3) and dispersion cover (4).
2. Fit a slotted screwdriver to the slit (5) in the nozzle and remove the nozzle cap (6)
by turning it fully counterclockwise.
3. Mount another nozzle with a different discharge hole.
Appearance Viscosity of chemical Example of chemical
Brass with big hole
Various
(gold color)
Aluminum
High
(silver color)
Brass
Low
(gold color)
Brass with a dot
Low
(gold color)
Nozzle 0.8
Aluminum
Small hole
MALATHION
(Mix with oil.)
Aqua K-Othrine
(Mix with water.)
Cipermetrinato
(Mix with water)
Nozzle 0.7
Brass
Small hole
13
(4)
(2)
(1)
Discharge rate (L/min)
0.3 - 2.5
(depending on the knob
position)
0.14
0.075
0.060
Nozzle 0.5
Brass
Dot (punch marking)
Small hole
(2)
(1)
(6)
(3)
(3)
(4)
(5)