Operation - Chicago Pneumatic CP 1210 Instrucciones De Seguridad Y De Funcionamiento

Martillos neumáticos manuales
Ocultar thumbs Ver también para CP 1210:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 68
CP 1210, CP 1230, CP 1240
Recommended insertion tools are listed in the
machine's spare parts list.
Narrow chisel
Moil point
Wide bladed chisel
WARNING
Vibration hazard
Using inserted tools that do not fulfil the criterias
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
Make sure that the inserted tool is
well-maintained, not worn out and of the proper
size.
Always use a sharp tool in order to work
efficiently.
9800 0608 90d | Original instructions
The narrow chisel is used for
www.CrowderSupply.com • Toll Free: 888-883-5144
demolition and cutting work in
concrete and other types of
hard materials.
The moil point is only used for
making holes in concrete and
other types of hard materials.
The wide bladed chisel is used
in soft materials, such as
asphalt and frozen ground.
Safety and operating instructions
Checking for wear on the tool shank
Use the gauge that corresponds to the insertion
tool s shank dimension. See section "Technical data"
for correct tool shank dimensions.
>
Check if the gauge s hole (A) can be pushed down
on the insertion tool s shank, this means that the
shank is worn out and the insertion tool should
be replaced.
>
Check the length (B), that it is according to the
ordered machine type.
Fitting and removing the insertion tool
Whenever fitting or removing the insertion tool the
following instructions must be observed:
To prevent an accidental start: switch off the air
supply and bleed the machine by pressing the
start and stop device. Disconnect the machine
from the power source.
Before inserting a tool, lubricate the tool shank
with grease.
Close the tool retainer and check the lock function
by tugging the inserted tool sharply outwards.

Operation

WARNING
Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
device until you are ready to start the machine.
Learn how the machine is switched off in the event
of an emergency.
Stop the machine immediately in all cases of
power supply interruption.
15

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Cp 1230Cp 1240

Tabla de contenido