Dremel 4000 Instrucciones De Funcionamiento Y Seguridad página 25

1600A012FM.qxp_4000 1/30/17 10:02 AM Page 25
Note: Each number settings listed in the speed charts = x 1,000 RPMs
* Speed for light cuts, Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Catalog
Number
9901, 9902, 9903,
9904, 9905, 9906,
9912
9909, 9910, 9911
Catalog
Number
612, 640
615, 617, 618
650, 652, 654
Catalog
Number
83142, 83322,
83702, 84922,
85422, 85602,
85622
Catalog
Number
516
500
EZ541GR
Aluminum oxide grinding stones (orange/brown)
Catalog
Number
541, 903, 911, 921,
932, 941, 945, 952,
953, 954, 971, 997,
8153, 8175, 8193,
8215
Speed Settings (Continued)
Tungsten Carbide Cutters
Soft Hard Laminates
Wood Wood /Plastics
25-35 18-24 9-11
- - -
High Speed Router Bits
Soft Hard Laminates
Wood Wood /Plastics
25-35* 18-24• -
25-35* 25-35• -
25-35* 18-24• -
Silicon Carbide Grinding Stones (blue/green)
Soft Hard Laminates
Wood Wood /Plastics
- - 12-17
Abrasive Wheels / Points
Soft Hard Laminates
Wood Wood /Plastics
4-6 4-6 -
4-6 4-6 -
- - -
Soft Hard Laminates
Wood Wood /Plastics
25-35 25-35 -
Aluminum, Shell/
Steel Stone Ceramic Glass
Brass, etc.
25-35 12-17 18-24
- - 18-24
Aluminum, Shell/
Steel
Brass, etc. Stone
- -
- -
- -
Aluminum, Shell/
Steel
Brass, etc. Stone
25-35 9-11 12-17
Aluminum, Shell/
Steel Stone Ceramic Glass
Brass, etc.
18-24 12-17
18-24 9-17
12-24 9-17
Steel Aluminum, Shell/
Brass, etc. Stone
18-24 9-11 12-17
18-35 18-35
18-35 18-35
Ceramic Glass
- - -
- - -
- - -
Ceramic Glass
25-35 25-35
- - -
- - -
- - -
Ceramic Glass
25-35 -
25