Operations; Turning On The Power - Sony RM-IP10 Manual De Instrucciones

Ocultar thumbs Ver también para RM-IP10:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operations

Before operation, make sure that cameras, IP remote
controllers, and peripheral devices are installed and
connected correctly. For details, refer to the operating
instructions of the camera and IP remote controller.
You need to assign a name and IP address to the camera
and IP remote controller that are connected to an IP
network when making an IP connection for the first
time. This setting is performed from your PC by using
the setting software "RM-IP10 Setup Tool." For details,
refer to the operating instructions of the IP remote
controller.

Turning on the Power

1 2
JOYSTICK
VALUE
LOCK
POSITION
KNOB
RESET
+
R
PRESET
MODE
BRIGHT
1
SHIFT
9
+
GROUP
B
SELECT
AUTO
FOCUS
AUTO
1
POWER
MANUAL
ONE PUSH
AF
NEAR
FAR
POWER
CAMERA
1
Connect the camera to an AC outlet.
The power of the camera is turned on and the
POWER lamp lights.
The camera will automatically pan, tilt, and be reset
to the position stored in POSITION 1 (Pan/tilt reset
action).
2
Press the 1 switch on the unit to turn it on.
When the unit is turned on, buttons and indicators
flash as follows:
Yellow (1 second) t Green (1 second) t Red (1
second) t The GROUP/POSITION button that
was selected when the unit was turned off last (with
the upper or lower indicator beside of the SHIFT
button and GROUP indicator) and the CAMERA
button (2 seconds).
8
GB
Turning on the Power
BLACK
PAN-TILT
ONE PUSH
GROUP
MENU
LIGHT
RESET
AWB
GROUP
POSITION
2
3
4
5
6
7
8
10
11
12
13
14
15
16
CAMERA
2
3
4
5
6
7
Then, the CAMERA button representing the
camera whose power was turned off last, lights.
(CAMERA 1 button lights by default.)
When connecting over a LAN, the unit starts with
the last camera group is selected.
3
Turn on the peripheral devices.
Notes
• Be sure to turn on the power of the camera before the
power of this unit. Otherwise, the unit cannot
recognize the connected camera.
• Do not touch the joystick when turning on the power
of the unit. Doing so may affect the confirmation of
the origin.
To turn on/off the camera using this unit
As long as the camera is connected to an AC outlet, you
can turn the camera on or off with the POWER button on
this unit.
While holding down the POWER button, press the
CAMERA button corresponding to the camera whose
power you want to turn on/off.
When you turn the power off using this unit, the
POWER lamp turns off and the STANDBY lamp lights
on the camera.
To illuminate the panel of the Remote
Control Unit
If you set DIP 2 switch 1 on the bottom of the IP remote
controller to ON, the GROUP/POSITION and
CAMERA buttons light.
To select the camera that you want to
operate
Press the CAMERA button corresponding to the camera
that you want to operate.
To change camera group number
Press any GROUP/POSITION button while holding
down the SELECT button. (For selecting 9 to 16, select
the camera group number while holding down the
SHIFT button.)
Note
You can change camera group number only when
connecting with LAN.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Brbk-ip10Brbk-ip7z

Tabla de contenido