Bosch 1594 Instrucciones De Funcionamiento Y Seguridad página 13

BM 2609140605 02-12:BM 2609140605 02-12 2/8/12 1:32 PM Page 13
STANDARD GUIDE FENCE
The guide fence can be used to control the
width of the cut or for simply providing added
stability and protection when cutting materials
that are up to 3-1/4" wide.
Note: When used for rabbeting, the fence
must be attached to the left side of the tool.
(Fig. 1).
Installing the guide fence: Place the wing
knob through the appropriate hole in the guide
bracket and screw into preferred side of the
housing. Securely tighten wing knob. Setting
the cutting width: Place wing knob through the
appropriate fence arm and slide along the
guide bracket to the desired position. Securely
tighten wing knob. Be certain that the flat
washer (supplied) is fitted between the bottom
of the guide fence and wing knob or the guide
fence is likely to slip.
DELUxE GUIDE FENCE
The deluxe guide fence can be used to control
the width of the cut or for simply providing
added stability and protection when cutting
materials that are up to 3-1/4" wide, with the
additional capability of guiding the planer on
any angle up to 45 degrees, to allow edge
chamfering and beveling (Fig. 12).
Note: The deluxe fence must be attached to
the left side of the tool. (Fig. 1).
Installing the deluxe guide fence: Place the
wing knob through the appropriate hole in the
guide bracket and screw into left side of the
housing. Securely tighten wing knob. Setting
the cutting width: Place wing knob through the
left fence arm and slide along the guide
bracket to the desired position. Securely
tighten wing knob. Be certain that the flat
washer (supplied) is fitted between the bottom
of the guide fence and wing knob or the guide
fence is likely to slip.
Setting the cutting width: Loosen wing
knob and using the width scale, slide the
fence along the guide bracket to the desired
position. Securely tighten wing knob (Fig. 1).
Setting the cutting angle: Loosen round
knobs and pivot the fence to the desired
position. Securely tighten round knobs
(Fig. 1).
Note that the adjustable front shoe contains
three chamfer V-grooves, which will follow
the corner of a workpiece to allow easier
handling when using the deluxe angle/width
fence (Fig. 13).
RABBETING DEPTH STOP
The optional rabbeting depth stop accessory
(Fig. 1) allows the user to set any rabbeting
depth from 0 to 5/16 inch. For best results, it
is important that the blade be properly
aligned (See "BLADE ALIGNMENT"). The
width of the rabbet is controlled by the width
fence. The final depth is achieved by
repetitive cutting until the rabbeting depth
guide contacts the workpiece. The maximum
rabbeting depth is 5/16"
Setting the rabbet depth: Loosen wing
knob and using the depth scale on the
rabbeting depth stop, set the desired rabbet
depth. Securely tighten wing knob.
FIG. 12
9 mm
max
FIG. 13
FIG. 14
9 mm
max
-13-
45°