The Set Setting Menu; The Install Setting Menu - Sony VPL-VW10HT Manual De Instrucciones

The SET SETTING Menu

The SET SETTING menu is used for changing the
settings of the projector.
SET SETTING
STATUS: ON
INPUT-A: COMPONENT
INPUT-B: COMPONENT
LANGUAGE: ENGLISH
POWER SAVING: OFF
SIRCS RECEIVER: FRONT&REAR
STATUS (on-screen display)
Sets up the on-screen display.
ON: Shows all of the on-screen displays.
OFF: Turns off the on-screen displays except for the
menus, a message when turning off the power,
and warning messages.
INPUT-A
Selects the computer, component, DTV YP
DTV GBR signal input from the INPUT A
connectors.
Note
If the setting is not correct, "Please check INPUT-A
setting." appears on the screen and the color of the
picture becomes strange or the picture is not
displayed.
INPUT-B
Selects the computer, component, DTV YP
DTV GBR signal input from the INPUT B
connectors.
Notes
• If the setting is not correct, "Please check INPUT-B
setting." appears on the screen and the color of the
picture becomes strange or the picture is not
displayed.
• Set the progressive component signal, e.g. DVD, to
"COMPONENT"; 15k RGB signal, e.g. game
machines, to "COMPUTER".
INPUT-A
P or
B R
P or
B R
The SET SETTING Menu / The INSTALL SETTING Menu
LANGUAGE
Selects the language used in the menu and on-screen
displays.
Available languages are: English, French, German,
Italian, Spanish, Japanese and Chinese.
POWER SAVING
When set to ON, the projector goes into the power
saving mode if no signal is input for 10 minutes.
The power saving mode is canceled when a signal is
input or any key is pressed.
SIRCS RECEIVER
Selects the remote control detectors (SIRCS receiver)
on the front and rear of the projector.
FRONT & REAR: Activates both the front and rear
detectors.
FRONT: Activates the front detector only.
REAR: Activates the rear detector only.
The INSTALL SETTING
Menu
The INSTALL SETTING menu is used for changing
the settings of the projector.
INSTALL SETTING
KEYSTONE MEM: OFF
DIGIT KEYSTONE: 01
INSTALLATION: FLOOR-FRONT
CINEMA BLACK: ON
LAMP TIMER: 234h
KEYSTONE MEM
ON: DIGIT KEYSTONE setting is stored.
The data is retrieved when the projector power is
turned on. The setting will remain the same every
time.
OFF: DIGIT KEYSTONE is reset to 0 when the
power is turned on the next time.
INPUT-A
27
(GB)