The Set Setting Menu - Sony VPL-CS2 Manual De Instrucciones

D:\Data\Oka\407983411VPLCS2CX1WW\02GB-
VPLCS2,CX1WW\05AJT.fm
The SET SETTING
Menu
The SET SETTING menu is used for
changing the settings of the projector.
SET SETTING
Menu Items
STATUS (on-screen display)
Sets up the on-screen display.
ON: Shows all of the on-screen displays.
OFF: Turns off the on-screen displays
except for the menus, a message when
turning off the power, and warning
messages.
INPUT-A
Selects the RGB or component signal input
from the INPUT A connector.
Note
If the setting is not correct, "Please check
INPUT-A setting." appears on the screen and
the color of the picture becomes strange or the
picture is not displayed.
KEYSTONE MEMORY
Memorizes the data adjusted with DIGITAL
KEYSTONE.
GB 30

The SET SETTING Menu

T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
INPUT-A
STATUS: ON
INPUT-A: RGB
KEYSTONE MEMORY: OFF
DIGITAL KEYSTONE: OFF
LANGUAGE: ENGLISH
POWER SAVING: OFF
SIRCS RECEIVER: FRONT&REAR
LAMP TIMER: 00010h
DIGITAL KEYSTONE
Adjusts trapezoidal distortion of the picture
that may occur depending on the projection
angle.
When the upside of the trapezoid is longer
than the downside : Sets to a plus
value.
LANGUAGE
Selects the language used in the menu and
on-screen displays. Available languages are:
English, French, German, Italian, Spanish,
Japanese and Chinese.
POWER SAVING
When set to ON, the projector goes into
power saving mode if no signal is input for
10 minutes.
SIRCS RECEIVER
Selects the remote control detectors (SIRCS
receiver) on the front and rear of the
projector.
FRONT & REAR: Activates both the front
and rear detectors.
FRONT: Activates the front detector only.
REAR: Activates the rear detector only.
LAMP TIMER
Indicates the total number of hours for which
the lamp currently used has been operated.
VPL-CS2/CX1
4-079-834-11 (1)
masterpage:Left