Connecting With A Computer - Sony VPL-VW10HT Manual De Instrucciones

Connecting

Connecting with a Computer

This section describes how to connect the projector to
a computer.
Select the "COMPUTER" in the INPUT-A or
INPUT-B of the SET SETTING menu.
Notes
• This unit accepts the VGA, SVGA, XGA or SXGA
signals. However, we recommend you to set the
output signal of your computer to the XGA.
• If you set your computer, such as a notebook type
IBM PC/AT compatible, to output the signal to both
the display of your computer and the external
monitor, the picture of the external monitor may not
appear properly. In such cases, set the output mode
of your computer to output the signal only to the
external monitor.
For details, refer to the operating instructions supplied
with your computer.
• Connect all the connecting cables to the INPUT A
connector when you input a signal from the INPUT
A connector.
Connect all the connecting cables to the INPUT B
connector when you input a signal from the INPUT
B connector as well.
16
(GB)
When connecting with a computer
Left side
CONTROL S IN VIDEO IN
PLUG IN POWER S VIDEO VIDEO
TRIGGER INPUT A
G/Y B/C /P R/C P SYNC/HD
B B R/ R
REMOTE INPUT B
RS-232C G/Y B/C /P R/C P SYNC/HD
B B R/ R
(FOR SERVICE USE)
Monitor
cable
SMF-400
(not
supplied)
to
monitor
out
Computer
Note
When you connect with a Macintosh computer, you
need an optional signal adapter.
.............................................................................................
1) When connecting INPUT A or INPUT B connectors
on the projector, you need conversion plugs.
VD
VD
Conversion plugs 1)
Speakers