Accessories; Sawing With Special Base Runners; Sawing With The Angle Table; Sawing With The Adaptation Table - Festool CARVEX PSC 420 EB Manual De Instrucciones Original

Damaged safety devices and components
must be repaired or replaced in a recognised
specialist workshop, unless otherwise indicat-
ed in the operating manual.
Observe the following instructions:
– Keep the air slits on the machine and the
charger free and clean to ensure adequate
cooling.
– Keep the contacts on the machine, charger
and battery pack clean.
– Check the guidance roller regularly for wear.
– Regularly remove dust deposits from the
chip guard.
– Regularly clean the base runner to prevent
scratches and cores on the surface.
Information on battery packs
– Where possible, store the battery pack in a
cool, dry place at a temperature between
5 °C and 25 °C.
– Battery packs are most efficient at temper-
atures between 20 °C and 30 °C.
– Protect the battery pack from moisture, wa-
ter and heat.
– Significantly shorter operating times after
each charge indicate that the battery pack is
worn and should be replaced with a new
one.
– The LiIon battery pack is fully compatible
with the charger! Integrated electronics pre-
vent overloading and overheating during the
charging process.
– Do not leave flat battery packs in a charger
disconnected from the mains power supply
for longer than one month. There is a risk of
total discharge and the maximum power of
the battery pack may decrease.
– Store the battery pack in its packaging to re-
duce the risk of short circuits..
– If LiIon battery packs are to be stored for
long periods without use, they should be
charged to 40 % capacity (approx. 15 mins.
charging period).
10

Accessories

The order numbers of the accessories and
tools can be found in the Festool catalogue or
on the Internet under "www.festool.com".
10.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli-
cations that are specially designed for your
Festool jigsaw.
10.2

Sawing with special base runners

The special base runners protect high-quality
surfaces against scratches and scores.
Press in the base runner at position [7-1].
At the same time, push the base runner
forwards.
Mount another base runner and push it to
the rear until it engages.
10.3

Sawing with the angle table

The angle table WT-PS 400 is used for cutting
pipes or interior and exterior angles up to 45°.
Dust extraction is not possible when
sawing with the angle table!
Installing the angle table
Remove the saw base [1-10], (see chap-
ter 7.4).
Position the angle table against the saw
base support.
Close the lever [1-8].
Ensure that the angle table is firmly seated in
the guide.
Setting the angle
Turn the adjusting wheel [8-1] to select
the required angle.
You can select the angles -45°, 0° and +45°
on the scale [8-2].
WARNING
Sawing cutting depths
Risk of injury
Select the saw blade length and cutting
depth so that the saw blade remains
plunged in the workpiece.
For 90° cuts, we recommend setting the
angle table to a small negative angle to
guarantee smooth operation.
10.4

Sawing with the adaptation table

The adaptation table ADT-PS 400 is used for
fitting your jigsaw on the Festool guide rail and
the circle cutter KS-PS 400.
With guide rail and circle cutter: do
not exceed max. material thickness of
20 mm and always use cross-set saw
blades (FSG).
Installing the adaptation table
Remove the saw table [1-10], (see chap-
ter 7.4).
C A R V E X GB
21