Working With The Machine; Acoustic Warning Signal; Service And Maintenance - Festool CARVEX PSC 420 EB Manual De Instrucciones Original

GB C A R V E X
8

Working with the machine

CAUTION
Material with high dust generation (e.g.
plasterboard)
Damage to machine through dust pene-
tration, risk of injury
Do not work overhead!
When working on small or thin workpieces, al-
ways use a stable base, or the CMS module
(accessory).
When working, hold the electric power tool by
the handle and guide it along the desired cut-
ting line. For precise cuts and smooth running,
use two hands to guide the electric power tool.
Free saw guidance along a scribe mark
The triangular pointer on the splinterguard
[5-1] indicates the cutting line of the saw
blade. This facilitates sawing along a scribe
mark.
8.1 Lighting
WARNING
The stroboscope light may make it diffi-
cult to determine the saw blade position
Risk of injury
Ensure the work area is well illuminated.
A continuous light or stroboscope is installed
for illuminating the cutting line:
up to approx. 2100 rpm: continuous light
from approx. 2100 rpm: stroboscope light
In overhead position (+/- 45°), the lighting
is switched off completely.
If required, you can adjust the lighting:
Plug in the electric power tool.
Press both buttons simultaneously [1-2]
and hold for approx. 10 s until a beep
sounds.
Release both buttons [1-2].
Press the left button (on the pendulum
stroke side) to select the stroke speed and
consequently the desired operating mode:
20
Mode Indication dur-
ing configuration
1 Light flashes
2 Light on
3 Light off
Press the right button to save the setting.
8.2

Acoustic warning signal

Acoustic warning signals sound and the ma-
chine switches off in the following operating
states:
Battery flat or machine over-
loaded.
– Change the battery.
peep ― ―
– Place the machine under reduced
stres.
Machine is overheating.
– You must allow the machine to
cool before using again.
peep peep ―
LiIon battery pack is faulty or
has overheated.
– Once
peep peep peep
cooled,
check using the charger.
9

Service and maintenance

WARNING
Risk of injury, electric shock
Always disconnect the battery pack from
the machine before any maintenance or
care work!
All maintenance and repair work which re-
quires the motor housing to be opened,
must only be carried out by an authorised
service workshop.
Customer service and repair
only through manufacturer or ser-
vice workshops: Please find the
nearest address at:
www.festool.com/Service
Use only original Festool spare
EKAT
4
parts! Order No. at:
www.festool.com/Service
5
3
2
1
Behaviour dur-
ing operation
With strobo-
scope (standard)
Permanent light
without strobo-
scope
Light switched off
the battery pack
perform a functional
has