Makita CS01 Manual De Instrucciones página 11

Cutting secured threaded rods
When cutting a threaded rod which is secured to the building struc-
ture such as the ceiling, wall, floor, etc., follow the procedure below :
► 1. Threaded rod 2. Cutting die on the stationary mount
1. Bring the tool so that the threaded rod is posi-
tioned between the cutting dies.
2. While the threaded rod contacting with the rod
guide, fit the thread of the rod with that of the cutting die
on the stationary mount.
3. Pull and hold the switch trigger until the cutting is finished
and the jaw of the cutting die comes to fully opened position.
NOTICE:
Clean the front face of the tool and the
tip of the guide scale before operation. They may
dirty the contacting surface.
Cutting loose threaded rods
When cutting a loose threaded rod on the floor or a
work table, follow the procedure below :
► 1. Threaded rod 2. Cutting die on the stationary mount
1. Position a threaded rod between the cutting dies.
2.
While the threaded rod contacting with the rod
guide, fit the thread of the rod with that of the cutting die
on the stationary mount.
3. Pull and hold the switch trigger until the cutting
is finished and the jaw of the cutting die comes to fully
opened position.
When cutting a long threaded rod which is hard to hold
by hand, place the tool as illustrated. The tool can be
placed flat. The cover also can be used for supporting
the end of the threaded rod.
1 2
1
3
► 1. Cover (Position 1) 2. Rod guide (Position 1)
3. Cover (Position 2) 4. Rod guide (Position 2)
The cover has markings to indicate its position.
Depending on the size of the threaded rod, put the
cover in the position as shown in the table as well as the
rod guide.
Quitting the cutting in the middle
CAUTION:
bly from the threaded rod. It may cause unexpected
start up which cause personal injury or damage to the
cutting die and tool.
1 2
When quitting the cutting in the middle, set the revers-
ing switch lever to the reversing position and pull the
switch trigger until the threaded rod is completely
released from the cutting dies.
11 ENGLISH
Position Size of threaded rod
1 W3/8, 3/8-16UNC, M10
2 W5/16, W1/4, 5/16-18UNC, 1/4-20UNC,
Never try to pull out the tool forci-
2
4
M8, M6