Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Guide scale
Use the guide scale if you wish to cut threaded rods in
the same length. Insert the guide scale into the hole as
shown in the figure.
2
► 1. Guide scale 2. Clamping screw
Align the value of your desired length on the guide scale
with the cutting line. Then tighten the clamping screw.
2
► 1. Guide scale 2. Cutting line 3. Clamping screw
CAUTION:
Do not hold the guide scale to
carry or handle the tool. The tool may fall off and
cause personal injury and/or damage to the tool.
Rod guide
For a precise cutting, set the rod guide in position
depending on the diameter of the threaded rod to be
cut.
► 1. Rod guide (Position 1) 2. Rod guide (Position 2)
1
1
There are two rod guide positions.
Position
1
2
Hook
1
CAUTION:
location or a potentially unstable surface.
CAUTION:
deformed or damaged.
CAUTION:
always fold the hook.
The hook is convenient for hanging the tool temporarily.
3
► 1. Hook
CAUTION:
waist belt. It may result in personal injuries and/or
damage to the tool if dropped.
2
8 ENGLISH
Size of threaded rod
W3/8, 3/8-16UNC, M10
W5/16, W1/4, 5/16-18UNC, 1/4-20UNC,
M8, M6
Never hook the tool on a windy
Do not use the hook when it is
When not operating the tool,
1
Do not hang the hook from the
Publicidad
Tabla de contenido
