Makita SC103D Manual De Instrucciones página 9

Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
► 1. Hex wrench
Shoulder strap
Optional accessory
Shoulder strap is useful for carrying the tool.
3
2
► 1. Shoulder strap 2. Belt end 3. Buckle
CAUTION:
Always wear the shoulder strap
crossed over your body and adjusted in proper length.
CAUTION:
Do not use the shoulder strap if it
is damaged.
CAUTION:
Leave an sufficient length between
the buckle and belt end to prevent the belt end
from slipping through the buckle.
1
3
2
Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at a Makita service
center.
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing the cutting dies
CAUTION:
in the correct directions and secured firmly.
Incorrect or loose attachment may cause breakage of
the cutting die, resulting personal injury by flown off
fractions.
NOTICE:
Remove the burr on the cutting dies
using a file if any.
1. Check if the jaw of the cutting die is fully opened.
If not, install the battery and pull the switch trigger until
the jaw is fully opened.
CAUTION:
cartridge if you installed.
2. Set the reversing switch lever to the lock position.
1
► 1. Reversing switch lever
3.
Unscrew the bolts with the supplied hex wrench.
CAUTION:
vided with the tool. Using other wrenches may
result in overtightening or insufficient tightening which
causes personal injury.
9 ENGLISH
Always be sure that the tool is
Always install the cutting dies
Be sure to remove the battery
1
Use only the Makita wrench pro-