Led Light - Makita SC103D Manual De Instrucciones

Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
To start the cutting operation, continue to pull the switch
trigger. The cutting die on the movable mount will
overlap with the die on the stationary mount and then
returns. If you release the switch trigger before complet-
ing the cut, the cutting dies will stop.
1
► 1. Switch trigger
2
3
► 1. Stationary mount 2. Cutting die 3. Movable mount
NOTICE:
Do not operate the tool at no-load
unnecessarily.
Auto-stop function
When you continue to pull the switch trigger, the jaw of
the dies once closes and returns to fully opened posi-
tion then stops. Release the trigger and pull it again to
begin the next cutting sequence.
Reversing switch lever
WARNING:
When not operating the tool,
always set the reversing switch lever to the lock
position.
CAUTION:
Always make sure the position of
the reversing switch lever before operating.
1
NOTICE:
Do not move the reversing switch lever
when the switch trigger is being pulled. This may
cause a damage to the tool.
To start the cutting operation, set the reversing switch
lever to cutting position.
To reverse the cutting sequence, set the reversing
switch lever to the reversing position. When you con-
tinue to pull the switch trigger, the jaw of the cutting die
opens and stops at fully opened position.
To lock the switch trigger, set the reversing switch lever
to the lock position. The switch trigger cannot be pulled
in this position.
1
► 1. Reversing switch lever 2. Cutting position 3. Lock
position 4. Reversing position
NOTICE:
When the reversing switch lever is in the
reversing position, run the tool only as needed. To
prevent the damage to the tool, the tool will automatically
stops when it is run in the reversing position continuously.
NOTE: After cutting, if you release the switch trigger
while the jaw of the cutting die is opening and then set
the reversing switch lever to the reversing position,
the jaw will once close and then open when you pull
the switch trigger again.

LED light

CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 15 seconds after
releasing the switch trigger.
► 1. Lamp (inside)
7 ENGLISH
2 3 4
1