Makita SC103D Manual De Instrucciones página 10

4. Set the cutting dies onto the mounts so that the
two colored markings can be seen.
3
2
5
6
1
► 1. Bolt 2. Cutting die 3. Stationary mount 4. Movable
mount 5. Colored marking 6. Hex wrench
5. Secure the cutting dies with the bolts firmly.
The cutting dies are correctly installed if the arrows on
them point each other. The dimensions of the cutting
dies are the same but their thickness look different
when seen from above.
3
► 1. Arrow 2. Cutting die 3. Thin side 4. Thick side
1
4
2
1
4
2
OPERATION
CAUTION:
Make sure that the correct size of
the cutting dies are installed to the tool. Check
the cutting capacity written on the cutting dies
before cutting.
CAUTION:
Before pulling the switch trigger,
be sure to set the threaded rod so that its thread
fits with those of cutting dies. Incorrect alignment
of the threads may break the cutting die and cause
personal injury by flown off fractions.
CAUTION:
Replace the cutting dies if the
cutting edge is chipped or deformed.
When cutting, place the threaded rod perpendicular to
the cutting line as shown in the figure.
1
► 1. Cutting line
NOTE: When cutting a threaded rod made of ductile
metal such as stainless steel, burrs may be generated
on the cut end. Remove burrs with a file in this case.
10 ENGLISH