Toto MS614114CEF Manual De Instrucciones página 4

2) Drill four 11/64" holes on the floor at
the location shown in the Unifit Rough-
In installation instructions found in
the Rough-In box (see Illustration 2).
(5/16" holes are for concrete / tile floor
anchors).
3) Turn the PVC outlet connection upside
down. Firmly press a new wax seal
onto the circular recess around the
outlet opening. Turn the outlet connec-
tion upright and lower it into position
over the closet flange. With the unit
properly aligned, press down firmly to
set the wax seal (see Illustration 3).
CA UTION: Do not move the outlet
connection after the wax seal is set.
4) Insert the washers and thread nuts
onto the mounting bolts and hand-
tighten (see Illustration 4). Then tighten
bolts an additional ½ turn. Secure the
back side of the outlet connection to
the floor using the 4 screws and wash-
ers.Insert the T-bolts into the slots with
the head down and threaded shank
pointed upward.
NO TE: Level the PVC outlet. Do not
use excessive force.
5) Lift the toilet and gently lower it into
position over the closet flange (see Il-
lustration 5). Make sure that the spigot
outlet of toilet slips into the rubber
sleeve and that the T-bolts fit through
the openings in the base of toilet.
Insert the washer and thread nuts
onto the bolts and hand tighten. Then
tighten the bolts an additional ½ turn.
Install the cover plates.
WA RNING! Do not over-tighten the
nuts. Damage to china or plastic
parts may result.
INSTALLATION PROCEDURE
4
Ill. 2
Finished Wall
B
2"
A
Ill. 3
Ill. 4
T-Bolts
Slot
Ill. 5
Nut
Washer
Cover
Plate
Floor
C/L
C
Closet Flange
Wax Seal
Nut
Bolt
Spigot
Outlet
Rubber
Sleeve